Views: 0 Author: Elio Publish Time: 2025-09-10 Origin: website
①Connect the valve: Locate the bubble house’s "air inlet valve" (usually screw-type or snap-on, marked with "IN") and tighten or secure the air pump’s connector to ensure no air leakage gaps.
②Select inflation mode:
First, use a high-pressure pump for rapid inflation. When the main body of the bubble house bulges and its outline becomes clear (about 80% full), switch to a low-pressure pump for slow 补气.
If only a single-speed pump is available, inflate until the surface is "elastic when pressed by hand and does not collapse." Do not over-inflate (this may cause seams to burst, especially as gas expands in high temperatures—reserve 10% of space).
③Close the air inlet valve: Immediately tighten the screw cap of the air inlet valve or fasten the snap after inflation to ensure a tight seal.
3.Securing and reinforcement (Critical! Especially for outdoor use)
①Ground stake fixation: Connect the "fixing loops" around the bubble house (usually on the bottom edge or sides) to the ground stakes. Insert the stakes into the ground at a 45° angle to ensure they do not loosen when pulled.
②Wind rope assistance: If the wind is strong outdoors, tie one end of the wind rope to the top or side pull ring of the bubble house and fix the other end to a ground stake to form a "triangular stable structure."
③Weight pressing: If no ground stakes are available, place heavy objects such as sandbags or stones on the bottom edge to enhance stability.
